www.boser.com.tw industrial power supply dc-dc dc-dc BPW-830C 300w dc-dc atx power supply input range: 19~32vdc *input voltage: 19~32vdc *input current: max. 20a at 24vdc *inrush current: < 5a at 24vdc input, cold start at 25 o c *ripple and noise: peak to peak ripple and noise is < 50mv for +5v and +3.3v outputs, < 100mv for other outputs when output voltage is at rated load *line regulation: < +/-1% for each output measured at rated load and +19~+32v input voltage variables *load regulation: output voltage load regulation is less than the value on the table when each output load changes rated loads from +/-40%~60%, with all other outputs at 60% rated load *output power: total dc continuous power is within 300w at < 30 o c ambient temperature and 24~32v input voltage; max. total combined output power on 3.3v and 5v rails is 150w *efficiency: 65% typical at nominal line and rated load *altitude: 10,000 feet *protection input: protection against wrong polarity when 24vdc input is inversely connected by mistake output: built-in over voltage protection circuit. trip point of crowbar circuit is between 5.9~7.0v. hiccup mode against short circuit or over load conditions auto recovery when faulty conditions are removed *temperature: 0~+70 o c (operating); -40~+75 o c (storage) *connectors : input: three positions terminal block dc output: output provides one at type p8/p9 and two disk drive connector *dimensions: 14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/-0.4mm tolerance between mounting holes *mtbf: 116,858 hrs. features features safety standards safety standards *safety: ul 1950 / csa 22.2 no.234 / vde en60950 *emi: fcc class b / en55022b *ems: level 3 of iec-801, 802, 803, 804 24v 0v harness dc wire 0.42 14.4 11.0 4.8 6.4 1.6 0.5 8.62 8.0 2.4 0.5 13.8 2.0 4 -tapping #6-32 0.35 0.4 14.0 2.7 0.6 output voltage +5v +12v -12v -5v min. load 2a 0.1a 0a 0a rated load 25a 10a 1a 1a max. load 30a 15a 2a 2a tolerance +/-0.2v +/-0.6v +/-0.6v +/-0.25v +3.3v +5vsb 0a 0a 8a 0.72a 15a 1.2a +/-0.135v +/-0.25v pin 1 2 3 input 24vdc 0v gnd output +5v +12v -12v p.g. gnd pin red yellow brown grey black -5v +3.3v +5vsb pwr on white orange purple green
|